I installed 3 new spektrum H3020s on my 450X. All appears good, except I have a few concerns
far as the 'cyclic limits' or 'end point's for each servo, once I enter parameter 'L' how is that done? Do I just use the right stick & go to each point as far as I 'eyeball it' & then press to get out of that parameter?
or do I use the right stick to go far as I want- again, 'eyeball'- & then with that position held w/ my right hand, use the left hand on the rudder stick to move & set it for each end point on each servo before I exit the parameter?
I also need to do the same adjustment for the rudder end point limits -- I could use advice on that too
thanks--
Wolf
far as the 'cyclic limits' or 'end point's for each servo, once I enter parameter 'L' how is that done? Do I just use the right stick & go to each point as far as I 'eyeball it' & then press to get out of that parameter?
or do I use the right stick to go far as I want- again, 'eyeball'- & then with that position held w/ my right hand, use the left hand on the rudder stick to move & set it for each end point on each servo before I exit the parameter?
I also need to do the same adjustment for the rudder end point limits -- I could use advice on that too
thanks--
Wolf