Articles
New articles
New comments
Search articles
Forums
New posts
Search forums
What's new
Featured content
New posts
New articles
New article comments
Latest activity
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Rc-Help Tech Section
Electronics
Charger Case Build | iCharger S6 1100W 40A
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Tony" data-source="post: 182375" data-attributes="member: 1"><p>Alright, I think this one is close enough to start the printing. I'm a little worried about wire length on the bottom parallel board to the charger, and I know I will have to make a new wire for the top board as that is a little longer than what it comes with. But all in all, it should work fine for now. </p><p></p><p>The fun part is I'm just going to use all of my old filament that I have laying around to print this so it's likely going to be multiple colors for the testing lol. </p><p></p><p>[ATTACH=full]25173[/ATTACH]</p></blockquote><p></p>
[QUOTE="Tony, post: 182375, member: 1"] Alright, I think this one is close enough to start the printing. I'm a little worried about wire length on the bottom parallel board to the charger, and I know I will have to make a new wire for the top board as that is a little longer than what it comes with. But all in all, it should work fine for now. The fun part is I'm just going to use all of my old filament that I have laying around to print this so it's likely going to be multiple colors for the testing lol. [ATTACH type="full" size="1077x728"]25173[/ATTACH] [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Rc-Help Tech Section
Electronics
Charger Case Build | iCharger S6 1100W 40A
Top
Bottom
