FBL Gyro Cannot change transnitter type in Microbeast Setup menu

jdelajaraf

New Member
Hi everyone, I hope you can help me with this issue since I have been trying to make it work for so long. I'm building an Align Trex 470 LT kit that came with a Microbeast Plus FBL Unit version 4.2. I have a Spektrum G8 Gen 2 transmitter and a Spektrum 8020T receiver and also a Spektrum DSMX Remote Satellite receiver. I have followed the instructions to setup the MB but the Receiver Setup Menu is not allowing me to change the transmitter type, after I power on the MB while holding down the button the status light turns blue but it does not change after pressing and holding the button down. I have tried with both the standard receiver and the satellite with no luck.
Can you help me?. Thank you.
 
Just want to ask the obvious, was this a new kit? And also, is the receiver bound to the TX? Are you sure its V4.2? I had one of those receivers go bad on me and I couldn't bind it anymore.
 
Yes!, you are right I was following an old video for building the Align kit and they were using version 4.2 that was the cause of my confusion. Thank you very much!.
 
Top Bottom