Reply to thread

Message: <blockquote data-quote="Lee" data-source="post: 90390" data-attributes="member: 33">Looking at an exploded view of the heli. 1) You will need to loosen the 4 bolts holding the tail boom to the frame. Slide the boom into the frame to release the tension on the belt.2) remove the screws that hold the tail case together. Take off the side that doesn't hold all the tail assembly.3) unhook the belt from the tail shaft pulley and turn it 180Âº (make sure to untwist it and not put another twist in.4) Replace on tail shaft and reassemble.Make sure when you slide the boom further out to re-tension the belt not to pull too hard. You should be able to push one side of the belt 2/3rds of the way across to the other side of it.Hope this helps</blockquote>