Hi Folks,
I am setting up my 3GX for my TRex 500. In rudder settings, I get the directions and limits set, no problem. In setting the delay, it settles at around 5. When I initialize the gyro and check for correction inputs from the gyro by swinging the tail, there is no response at all. No servo movement left or right to correct. This is on the ground and not flying. Surely I should get the gyro corrections ?
I am setting up my 3GX for my TRex 500. In rudder settings, I get the directions and limits set, no problem. In setting the delay, it settles at around 5. When I initialize the gyro and check for correction inputs from the gyro by swinging the tail, there is no response at all. No servo movement left or right to correct. This is on the ground and not flying. Surely I should get the gyro corrections ?