3DDevil
New Member
Hello All,
I recently upgraded my Align Trex 600N heli with a flybarless head setup. I purchased the 3GX to go with the setup.
I have set the heli up mechanically and I am currently getting 12 degs pos pitch and 13 negative. So the head is close to centre. I have gone through the setup of the 3GX and it would appear that I have set everything up OK. I have set the travel limits with the 3GX for aileron and elevator. The main trims are on centre, but I had to add a little sub trim in radio to get everything lined up 90 degs. Thats the only radio setting up I have done with this setup.
So, when I move the stick to full aileron deflection, no binding occurs. When I move the stick to full elevator deflection, no binding occurs.
But when I move the stick to full aileron combined with full elevator deflection the swash plate is binding against the main shaft.
Any ideas why this is occurring?
Thanks for any advice.
Bill
I recently upgraded my Align Trex 600N heli with a flybarless head setup. I purchased the 3GX to go with the setup.
I have set the heli up mechanically and I am currently getting 12 degs pos pitch and 13 negative. So the head is close to centre. I have gone through the setup of the 3GX and it would appear that I have set everything up OK. I have set the travel limits with the 3GX for aileron and elevator. The main trims are on centre, but I had to add a little sub trim in radio to get everything lined up 90 degs. Thats the only radio setting up I have done with this setup.
So, when I move the stick to full aileron deflection, no binding occurs. When I move the stick to full elevator deflection, no binding occurs.
But when I move the stick to full aileron combined with full elevator deflection the swash plate is binding against the main shaft.
Any ideas why this is occurring?
Thanks for any advice.
Bill