jwcole1968
New Member
I bought a Erazor 250, Replace the rx with a Spektrum so I could use my Dx6i. I setup the helicopter and Tx using the setting Tony used in his Erazor 450 setup video. Everything was fine. It worked perfect (inside) it hovered and responded correctly. As I set the 250 down so I could go outside, dumb thumbs occurred, and I touch the concrete floor with one of my main blades and broke the feathering shaft. I replaced the Feathering shaft Main blades and the flybar, for good measure. Now there is a bad wabble when I try to hover, the whole heli wabbles. I even pulled the main shaft out to see if it was warped, but it was good. Blades are balanced... Does anyone have any ideas what might be going on?