Khellio
New Member
After watching Tony's video on the topic on YouTube, I followed his instructions only to find on completion that although the TX was indicating that binding was complete, when I tried to run the motors, the throttle stick was dead.
I've tried all of Tony's suggestions to rectify the issue, but so far I haven't found a solution to the problem>
I actually bought 2 of these from Banggood and I'm experiencing the same issue with both.
It kinda reminds me of a similar issue myself and several of my club members had with the HobbyKing "orange" DSMX compatible receivers in that while the TX would indicate bind complete and all the control surface servos would work normally, in 8 of 10 cases, the throttle would not.
Anyway, I'd sure appreciate it if someone could come up with a solution to the Beecore F3 issue as it's unlikely asking Banggood for a refund is likely to work in this instance as they've both had the power supply connections soldered on.
I've tried all of Tony's suggestions to rectify the issue, but so far I haven't found a solution to the problem>
I actually bought 2 of these from Banggood and I'm experiencing the same issue with both.
It kinda reminds me of a similar issue myself and several of my club members had with the HobbyKing "orange" DSMX compatible receivers in that while the TX would indicate bind complete and all the control surface servos would work normally, in 8 of 10 cases, the throttle would not.
Anyway, I'd sure appreciate it if someone could come up with a solution to the Beecore F3 issue as it's unlikely asking Banggood for a refund is likely to work in this instance as they've both had the power supply connections soldered on.