D.O.G.
Goblin 380 Supporter
OK, I've been using Omnibus F4 V2 FC for awhile now. Recently on my 210 the USB port connector on the FC broke. I finally got around to change it out with another new Omnibus F4 V2 FC. Well this time, for some reason I can't get the FC to arm with my switch. I've tried everything and nothing seem to work even though my 180 has the same FC and set up the same way. I haven't done anything different or changed anything on the FC setup or the TX setup. In the past I haven't had any problem with these FC and been very pleased with them til now. I tried different firmware and still nothing. Everything else works fine like the receiver tab, motor tab and mode tabs but still can't arm with switch. Has me baffle since I didn't do anything beside change out FC. I'm thinking the FC is no good. Any ideas will be appreciated. I'm not a happy camper !