Turnigy 9xr setup

[1evlfx]

Hi I'm new to heli flying and I'm needing help to set up my turnigy 9xr remote
To my trex 450 pro with 3gx gyro fbl system.
I have started setting up 3gx using rc-help.com YouTube videos
But am having trouble setting up 9xr can't get swashplate to lift up and down with throttle
To change pitch ..
Ch1 : thr
Ch2 :ail
Ch3 :else
Ch4 :rid
Ch5 :full gea
Ch6 :ail

Curves

Cv1 -100 -20 30 70 90
Cv2 80 70 60 70 100
Cv3 100 90 80 90 100
Cv4 -30 -15 0 50 100
Cv5 -100 -50 0 50 100
Cv6 -100 -50 0 50 100

Any help appreciated

 

[DavidDutch]

But how did you setup the 3GX if the sticks don't respond?

Normally if you start setting up a FBL unit you leave the curves, trims at standard. PC (pitch curve) 0-25-50-75-100, TC (throttle curve) 0-25-50-75-100. trims in centre position

Have you already programmed the ESC (what ESC are you using), have you connected the RX the right way, the correct channels to the 3GX. What RX are you using, is it correctly bound with the TX




Please explain step by step what you have done

- - - Updated - - -

and what motor, servo's etc do you have

 

[1evlfx]

Re: Turnigy 9xr setup ......

But how did you setup the 3GX if the sticks don't respond?

Normally if you start setting up a FBL unit you leave the curves, trims at standard. PC (pitch curve) 0-25-50-75-100, TC (throttle curve) 0-25-50-75-100. trims in centre
Hi David
The heli is secondhand and was previously set up on a dx9 spectrum tx ..
All the sticks work and motor spools up when connected .

But when u move thr stick the swash doesn't move to change the pitch of the
Blades and I'm not sure how to set that up on my turnigy 9xr tx .

The 3 servos connected to swash are savox digital sh-0257mg
And the rudda servo is align digital ds520 .esc is the one that comes with the kit
And so is the motor ..and it has 2 spectrum sat receivers ..
All I have done with the tx is bind it to heli and set it to simple
6 channel setup and set limits so swash is level and
So rudda has full travel and doesn't bind .

And I have checked to make sure all servos are connected correctly
And that connectors from servos to swash are the correct length



Cheers Dion

 

[murankar]

The firmware on the 9xr is not your normal firmware. The mixes are all on one page and you can assign any mix to any channel.

The first three are throttle curves and the next three are pitch. I did not see what he has exactly but from what I saw on the throttle those should be adjusted a little.

0 40 75 75 75

75 75 70 75 75

85 85 80 85 85

The second one can be bumped up to 80 but I think 75 is a good iu1 for starters.

Sent from my LG-E980 using Forum Runner