Hello everyone,
I have had my HBK3 for a little while now, and recently just purchased a DX8 to use with it. I have done some research online as how to go about doing this, but I haven't been able to find anything that is clear cut step by step. My first problem is that I've read I start out with all servos at at 90 degrees using sub trims, and then level out the swash plate by adjusting the servo linkage. Is this correct ? I haven't figured out how to get the 3d F-Mode to work properly yet, the throttle curve for it is good but the pitch curve is killing me. Do any of you guys know were i can find some information on this or able to help me with it?
Thanks
I have had my HBK3 for a little while now, and recently just purchased a DX8 to use with it. I have done some research online as how to go about doing this, but I haven't been able to find anything that is clear cut step by step. My first problem is that I've read I start out with all servos at at 90 degrees using sub trims, and then level out the swash plate by adjusting the servo linkage. Is this correct ? I haven't figured out how to get the 3d F-Mode to work properly yet, the throttle curve for it is good but the pitch curve is killing me. Do any of you guys know were i can find some information on this or able to help me with it?
Thanks