General Need help with vbar gyro

[Blackwarrior]

Hey guys, I've got a little problem with my mini Kbar gyro.. Don't have a video.

I've set it all up with my laptop properly, I think......

When I power it up and spin it up it's fine right up until it gets light on the skids then it spins 180 degrees. At this point I just throttle down... I dare not keep it going... Scary man..

Any ideas at all?

 

[treff]

Could be your tail is reversed, pushing the wrong way. Go back into the software and change direction

 

[Lee]

Have you done the tail checklist from my gyro servo video?
As Treff said, tail comp could be the wrong way.

 

[Blackwarrior]

Thanks guys, yes it was tail reversal in the software, I've watched your video loads of times Lee, one day it will sink in..lol

I'm not getting online much lately with the grandkids...