Micro Nano CP X Shutdown Glitch

[hyp0r]

I'm having a problem with my Nano CP X, when I'm flying around the whole thing will shut down for a second and then kick back on. Depending on the maneuver I'm doing, this often times causes a crash.

I read on the forum here that the main motor might be causing some kind of overload, which might cause this to happen. I replaced the main motor, no luck. I looked at the circuit board and everything looks okay.

Here's a video of the problem. I'm not adjusting the throttle or even touching the TX during this video.

[video=youtube_share;kgHBJckw5QQ]http://youtu.be/kgHBJckw5QQ[/video]

(The landing skid almost came off when I was filming this. Luckily it didn't, whew!)

Any ideas on what might be wrong?

Thanks!

 

[Lee]

Its hard to say, but you tried one of the things already.
Other possibilities are, loose or bad solder joint. Bad tail motor, or some issue with the board.
I would give Horizon Hobby a call, and send them the video. See what they say.
Good luck.