I was trying to calibrate the throttle range of my new esc's and the steps I use was
Turn on tx and raise throttle position all the way up
Connect esc's to battery and wait 2 seconds
Get a 123 beep beep sound that indicate highest throttle point has been configured
Move the throttle to bottom and wait 2 seconds
Beep Beep tone means lowest point has been configured
Them move throttle sticks to arm motors
Its the part where I move the throttle stick to the bottom that I don't get any beeps
Turn on tx and raise throttle position all the way up
Connect esc's to battery and wait 2 seconds
Get a 123 beep beep sound that indicate highest throttle point has been configured
Move the throttle to bottom and wait 2 seconds
Beep Beep tone means lowest point has been configured
Them move throttle sticks to arm motors
Its the part where I move the throttle stick to the bottom that I don't get any beeps