General Blade 200

[Richyrich]

Hi all

As you apply power on lift off my swash plate leans forward and to the left and I have been told that yo correct if I need to perform a trim flight. I'm now familiar with the procedure but for some reason I can not get it to go into trim flight mode no matter what I do.

It's setup to a dx9 and all the settings appear correct.

Has anybody come across this problem and found a way round it?

Any help or advice will be much appreciated.

Richard

 

[Tony]

Do you have your Tx setup as per the manual? Below is a picture of the DX9 setup for the 200 SR X. And are you initializing the helicopter on a stable, level surface and not touching it until it's initialized?

 

[Richyrich]

Hi Tony
Yes I'm doing all as you suggested and the radio is set as per HH directions.
Richard