I have a T-REX 450 FLB with a Align 450 brushless motor and a 30A Align ESC. Hooked up the Motor - ESC to the bound receiver and programmed the ESC. Unplugged everything bad powered back up with throttle stick down. ESC when through my Programing all is good. Tried to throttle up the motor and all that happens is the Motor vibrates for a second then nothing. Is the ESC or Motor bad ? I'm new so I may have missed something ?
General Bad esc or motor ?
- Thread starter Wpw
- Start date
Tony
Staff member
The only way to test this is with another motor and ESC. I would try to rebind just to be safe. I would also turn everything off, turn your Tx on and raise the throttle all the way up. Plug in the helicopter and wait for the First two beeps. Once you hear those, lower the throttle all the way. This will reset your endpoints. If that doesn't help, then you will need to find a way to test the motor with another esc, and test the esc with another motor.