Other After binding help

[D.O.G.]

Hello, once again i can use some insistence. I'm binding a Walkera Devo 7 Tx and Devention devo Rx 601. After all's been binded and the Rx/Tx done initialize, how do i center the servos? Do i center the Tx and then install the servo arms close to center then adjust through the Tx to get even closer to center. This Rx doesn't have a button to center the servos so i'm kinda lost. There is a hole in the Rx that saids clear on it but i don't know what that will do. Any help will be appreciated.

 

[Tony]

You are right, just bind as normal then center the sticks and get the arms as close to 90 as you can. From there, depending on what you are putting this on, you will either use the gyro or the subtrim in the Tx to completely set the arms to 90 to the links.

 

[Lee]

What he said