Flight Controllers afro flight Rev5 naze32

[cherokee-T]

hi all would someone tell me if u setup the board 1st motor/esc with all 3 wires signal white'power red'ground black 2nd 3rd
and 4th motor/esc just the signal white. or do you have to install the ground black to ?

 

[Lee]

If they are linear BECs you can leave all the wires in. If they are switching BECs then just remove the red wires.

 

[cherokee-T]

i have lumenier 12a are they linear? and i'm using frsky D4R-ll cppm

 

[Lee]

I can't see if they are or not. So to be safe, just remove three of the red wires and leave the one with, to power everything.
Normally its the number one motor that has the red wire.

 

[Slobberdog]

does not matter on the naze32 as the ground pin set are common bus and positive as well,

I have mine powered off esc number 4, as this was the one I had set up as #1 when I had the CC3d on the quad.

 

[cherokee-T]

thanks for the info