Search results

  1. A

    FBL Gyro Ikon2 Question

    How to enable data logging. I have set logging on at 50 hst and can see live logging but when I disconnect from Ikon software and then power up the heli it does not record data. When I go back into software to see logging it shows as disabled again.Im using two DSMX satellite receivers. I’m not...
  2. A

    FBL Gyro Ikon2 Question

    Thats awesome. Thanks a million for the quick response.
  3. A

    FBL Gyro Ikon2 Question

    HelloAll I have recently set up two helicopters with the Ikon2 and have been flying them with good success. Now I want to activate the rescue feature. In the rescue page you can select which flight mode you want rescue active and I have set up the aux2 channel on a switch to activate rescue. In...
  4. A

    General Ikon2 Question

    Sorry Tony I had not seen your response when I posed my question to Admiral. Best regards
  5. A

    General Ikon2 Question

    Thanks so much Tony. I believe you stated that the 0 position effectively turned off the tail gyro. So as I understand your explanation I should take off in the o position with the tail centered and then switch to HH for flying.
  6. A

    General Ikon2 Question

    Thank you Admiral I see. So presumably I could just set the gyro to on without a switch and fly as normal with a positive setting ? Or use a switch with different positive values to match the gyro to a particular setup that I may be flying? What would the rate mode assist with during setup ?
  7. A

    General Ikon2 Question

    Hello, I have just set up a new Align 550x with the Ikon2 FBL following the video that Tony did a few years back. My questions pertains to the setup of the gyro On a Spectrum DX9 which I have done per his instructions on a three way switch with values of 57%,0%,-57%. When in postion 1...
  8. A

    Misc. Ikon2 Setup Question

    Thanks for the reply.
  9. A

    Misc. Ikon2 Setup Question

    Hello All, New here to the forum and have only been flying helicopters for 1.5 years. I am setting up an Ikon2 for the first time on an Align 550X. It seems fairly straightforward using the wizard, but I am confused with whether I should use DR/Expo in my Spectrum DX9 or is that covered with the...
Top Bottom