Search results

Thank I will try to check up on that

I have a qav 250 with cc3d, 20a blheli escs, 2300kv motors for some reason when I start flying it it hovers for a few seconds then all the motors stop spinning then just fall on to the ground. Does anybody know what's wrong?

I'm bought a qav 250 kit with a cc3d,20a escs,2300kv motors,mini cc3d pdb, and then the frame but I don't know how I'm going to power the cc3d if the escs don't have a red or positive wire just signal and ground and the pdb doesn't have a 5v out. what can I do?

We Well now nothing is working because my cc3d won't go in Boot load mode while upgrading i don't what's wrong

My motors are making weird sounds, anyone know what's going on.

The motors and receiver are working now but there's another problem which I don't know what is. Here's a video

I have a cc3d and I have everything connected up correctly I double checked but there are no signal to the esc and motors when I move the throttle. Does anyone know what's wrong?

I have a cc3d connected to a receiver pwm and I checked the connections but the cc3d is not powering the receiver. Does anyone know what's wrong?

I have cleanflight on a naze32 rev6 and everything is connected up right and my receiver is connected pwm but only my aux channels are showing signal on clean flight what do I do?

I will check

It's connected by pwm

Yes it is a data type cable

I already made sure of that but still not working.

I have a naze 32 rev6 with cleanflight on it. It is able to connect and everything but when I go to transmitter and turn on my transmitter it shows no signs that a transmitter is connected I even rebinded my Rx and TX but it's still not working can anyone help?