Search results

  1. B

    FBL Gyro Ikon2 Govenor Page, Throttle Setting

    Thanks again Tony, I do the same thing with my new ESC's I calibrate the min and max throttle points on a separate Rx before installing in my heli with my Ikon/Brain 2. It makes sence to me what you said regarding panel 5 and 12, so I will try it out and let you know how it goes, posting here...
  2. B

    FBL Gyro Dx6g3 Tail Gain Tuning Ikon2

    Tony, thank you very much for the reply, your very appreciated, and I enjoy all the Heli videos, they have helped me alot. I am wanting to get a DX8G2 though it will make setup much better with the Ikon. Take care!
  3. B

    FBL Gyro Dx6g3 Tail Gain Tuning Ikon2

    If I dont have a switch setup for banks will the Ikon leave me with a default bank, so I can leave my gyro on a switch to adjust the gain? Thanks
  4. B

    FBL Gyro Ikon2 Govenor Page, Throttle Setting

    Ok sounds good, thank you for the help, I set up an Ikon2 a couple of years ago, and panel 12 was different then, I could just skip it if I didn't use the govenor. Take care!
  5. B

    FBL Gyro Ikon2 Govenor Page, Throttle Setting

    Thanks for the reply Matt, I am not using the govenor either but, do I need to go through the throttle calibration on page 12, Tony did in the video but he just verified the transmitter was showing 0 to 100% and had the battery disconnected. The Ikon2 instructions on panel 12 states its...
  6. B

    FBL Gyro Ikon2 Govenor Page, Throttle Setting

    Hi I just watched Tony's video with the Ikon2 and the Goblin. On the govenor page I noticed he did not run the motor to set the min and max throttle settings. Is this nessesary to do with running the motor, it seemed the instructions required it or did I miss understand it? I am not planning on...
  7. B

    FBL Gyro Spektrum DX6 Ikon2 Programming

    Hey everyone, I figured it out I found the video Tony did for this, Thanks.
  8. B

    FBL Gyro Spektrum DX6 Ikon2 Programming

    Hello, I am having a little trouble figuring out how to get the 3 flight modes set to a switch and how do I set a switch for the autolevel? I have the Gen2 Dx6. When I go into channel Inputs and scroll down it skips the Aux channel which shows INH. thanks in advance.
  9. B

    FBL Gyro Ikon2 on Trex 450pro v2

    Great thanks everyone for replying, still building my first 450 Pro V2 DFC.:biggrin1:
  10. B

    FBL Gyro Ikon2 on Trex 450pro v2

    Hi everyone, I had a quick question regarding the Ikon2. I will be putting this on my 450 Pro V2 with the upgraded dfc head. I will be using the new Dx6. Will I be ok just using the Ikon and one Satellite with this? Thanks, Darren
Top Bottom