Search results

  1. inganeer

    Testing The Alerts

    Yippy
  2. inganeer

    heli-lo from Missouri

    Thanks KLA for the warm welcome.
  3. inganeer

    500 AR7210bx, Tail servo wont self center

    Been real windy and now rain. Bummer. I did take it long enough to spool it up to center. Had a noise come up that resembled an engine cutting out. Brought it back in and after several hours of looking and reading I found the tail rotor hub was not tight. Got it tight and pulled the blades and...
  4. inganeer

    500 AR7210bx, Tail servo wont self center

    Re: heli-lo from Missouri You were right. I had it backwards. I'll give it a spin tomorrow. Thanks again.
  5. inganeer

    500 AR7210bx, Tail servo wont self center

    Re: heli-lo from Missouri Awesome, Thanks, got a couple of honey do's to do and I'll give it try.
  6. inganeer

    500 AR7210bx, Tail servo wont self center

    Re: heli-lo from Missouri I'll give that try. Thought I had everything down pat but anything is possible. I went through the setup 5 or 6 times. Almost have it memorized now. LOL. Really do appreciate the input on this. Momma's not real happy that I spent what I did and it hasn't hit the air yet.
  7. inganeer

    500 AR7210bx, Tail servo wont self center

    Re: heli-lo from Missouri I was afraid of that. End points are good. May have too cut my gains back till I can get used to it. My thought was to tighten it up like my 200srx till I got comfortable with it. - - - Updated - - - The one thing I noticed earlier today just spooling it up was that...
  8. inganeer

    500 AR7210bx, Tail servo wont self center

    Re: heli-lo from Missouri It moves back and forth normally. I just assume when you let off the stick it would go back to center.
  9. inganeer

    500 AR7210bx, Tail servo wont self center

    Re: heli-lo from Missouri When I first start it up everything is perfect but if you give it any rudder, it stays where it stops at. I assumed it should return to center like it did before I changed everything.
  10. inganeer

    500 AR7210bx, Tail servo wont self center

    I have the remnants of a Belt CP with a 450 frame and a Ar7210bx with firmware upgrade. I can't get the tail servo to self center. I'm a newbie but understand some of this. Been putzing with this most of the day and can't figure it out. I know it is probably something simple but smarter than me.
  11. inganeer

    500 AR7210bx, Tail servo wont self center

    Well the only things that survived the last crash were the canopy, tail belt, tail gear and motor. I pickuped a EXI CF frame and a CF boom and started over. I now have an Align BL430X and a Align 60A ESC. Also picked up an AR7210BX and the firmware upgrade. A new cheap DFC head. Now to figure...
  12. inganeer

    heli-lo from Missouri

    Hello, I'm Ed from Springfield, Missouri. I am a newbie at this and have lots of questions. Let me start off with my first heli is/was a Esky Belt CP I picked up at a yard sale for $5. I should have walked away but Nooooooo, I just had to have this. LOL. Anyway I have spent a fortune on this so...
Top Bottom