Search results

Again, Thank You Tony... Sorry to be such a pain. Your the best!

Should it just be under "N" in the transmitter or should it be all?

In the Transmitter. They say that when you setup the BeastX you should use a linear curve but the photo settings that I posted they are not linear for the transmitter.

One last thing Tony, to setup the Beast-X do I make all the "n" settings to linear?

Once again Tony, Your The Best... Thank You!!!!!!!!

Your right again Tony.... I works great!!!!! Thank you!!!!

I have a Blade 450 X Helicopter with the Beast X - AR7200BX. What I need to know is what should all the settings be in the Spektrum DX7s Transmitter. In the manual that came with the helicopter it has some crazy settings that I don’t think are for me. I don’t fly 3D so all I want is the basic...

I'll give it a try and see what Happens... Thanks Tony

I don't think you can use dual rates or expo with this.

Hi Guys, My question is, I put the Arkbird Autopilot System w-OSD V3.1028 in my H-King Voltigeur airplane using a Taranis Plus transmitter and I use my two position switch to disable the thr. channel so I used a three position switch and in special functions I override the middle part of the...

This worked for me by the following steps: 1- Turning on you transmitter, throttle up to max 2-Plugging in your battery (the board then understand you're in programming ESC mode) 3-Wait until the Pixhawk fully loads 4- Push safety switch for 5 seconds, you should hear the Pixhawk send the...

I looked on Spektrum's web site and they don't have the Spektrum H3050 servos listed but that's is what's on the servos.

Hay, Thank You Guys I looked everywhere and couldn't find this information. I watched your video on the setup and you make it look easy and it was. Thank you again!!!!!!!!!!!

Hi Everyone, Does anyone know what the servo frequency's are for the Spektrum H3050 Heli Cyclic & KST DS215MG rudder servo? Also With the BeastX in setup "N" my swash plate moves on both settings, can anyone tell me what I need to do!

Hi, I use the Turnigy 9xr pro transmitter and I use the orange module in the transmitter and all the orange receivers and Spectrum receivers. They all work well amd never had a problem!

Hope no one did that yet because I found out that this will only work in GPS or Attitude mode... never in manual mode because manual mode puts all the controls on the pilot. Don't ask me how I found out... It wasn't pretty :-) good thing their was no damage or hurt anyone!!!!!! With that said...

Bright colors, should be easy to see where you are!!!!

Thank you, D.O.G. I have flybar Helicopters, flybarless Copters, a jet, I just finished building the DJI Flame Wheel F-450 Quadcopter with the NAZA-M Lite autopilot with GPS which is great to fly. I love to build also I guess they go hand and hand:-)

Hi, I did calibrate the throttle many times and got the same problem. After burning out the first one trying to get it to work then I found out from watching a video on youtube just takeoff the gyro fixes the problem once you liftoff!!! There tech people didn't know what to do about it.

My Airplanes, Helicopters & Quad copters.