Micro Blade Cpx Blade Grips

H

Hirobo.61

Member
While flying my Blade nano cpx, ablade grip(with rotor blade attached) flew off. Luckily, I was able to retrive all the parts, but I can’t figure out how to re-install the blade grips. Can anyone explain the procedure for me?
 
Admiral

Admiral

Well-Known Member
The feathering shaft appears to a long skinny bolt with a nut ob the other end you will probably need to replace item "L" with a new feathering shaft Part Number BLH3313.

upload_2018-10-18_15-44-44.jpeg
 
Tony

Tony

Staff member
Agreed, even if the feathering shaft didn't break, it is likely stripped out and now bent. Definitely replace it.
 
H

Hirobo.61

Member
Thank you guys...any ideas how to hold the tiny bolt and nut to tighten them? Seems like watchmaker tools are all that would get into the blade grip.
 
Tony

Tony

Staff member
You just put a very small amount of thread locker on the bolts and tighten them (not too much) at the same time.
 
H

Hirobo.61

Member
I truly appreciate your input and patience, but I can’t find a tool small enough to grab the tiny bolt and nut and that is small enough to work within the blade grip. Am I missing something?
 
Tony

Tony

Staff member
I think this is the tool you need. You said something about grabbing the nut, I'm guessing you are talking about the feathering shaft? If so, since one of them broke or stripped, just replace both the feathering shaft and the bolts. There could be an issue in the metal that caused the issue.

Blade Spindle Tool Set: nCP X
 
You must log in or register to reply here.
Top Bottom