Here is my layout. All wires run inside the frames back to the VBar Neo. Tail servo goes through the frame side, esc drops down along the side and zip ties to keep it in place.
Cyclic runs back to the tail block and drops down between the block and frame sides. Then zip tied in place. I kept the right side frame off till all the wiring was done. Then I finished up by fastening the frame side in 0lace.
View attachment 21088
View attachment 21089 View attachment 21090 View attachment 21091 View attachment 21093
View attachment 21094
One thing you can do is shorten the servo wires to exact lengths. Takes a crimper but makes it look really good.
I have a video series on YouTube for the build.
The X3s are tiny machines and have very little realestate available for wiring. Not to mention I crash them a LOT, because I tend to fly them like I hate them. I don`t get too twisted about making them neat, and tidy like I do with the 700s... I just make their wiring functional. I mount the receiver and FBL unit on the rear, over the transmission, and kinda jumble the wires as best I can and tie them off with a velcro strap.
Like I said, it`s just an X3. I just finished repairing it today, and I`ll be surprised if I don`t bring it home in a walmart bag on Saturday.OMG MY EYES!!!!!!!