Align 600 Nitro (Murphy)
600/700 Feathering Shaft Wrench - http://amzn.to/2CTtvfc
450/500 Feathering Shaft Wrench - http://amzn.to/2CU5GUt
It is time to get Murphy back up in the air. But before I would feel safe flying this helicopter, we need to go completely through him and clean and lube every part of this...
February 1st, 2013 was the last time the RCH Heli, AKA Murphy, the Align 600 Nitro, was put into a public video. Well today, that changes!
In this video, I catch you up on what has went on with the bird, why it has set so long and what we are planning to do with it in the future.
If you...
I'm sure by now you all have read my first impressions on the RCH Heli. And to say that I was less than impressed with what we ended up with is an understatement. If you are an RCH Supporter, you know what I have went through on this heli. For those that have not read my First Impressions...
Finally, we get the heli back to looking like a heli!
Finally, we are getting somewhere with the RCH Heli. In this video, I figure out that we are running version 1.1 on the 3GX and then I show you how to flash it to version 1.2. Yes, we are also going to run version 2.1 and version 3.0, but all in due time. As stated in teh video though, I'm sure...
It's about time we get some servos installed on this bird. Boring video, but all in building a used heli!
This is not exactly an instructional video, but more of a video showing the progress of the RCH Heli as promised to the donors of this helicopter.
In this video I go through rebuilding the head of the used Align Trex 600 Nitro Super Pro. Just because this is a larger heli, doens't mean that anything has changed. There are still thrust bearings in it as well as regular bearings and being a flybarless heli, there is a swash driver on this...
In this video, I go through rebuilding the tail on the Align T-Rex 600 Nitro Super Pro. This is oen of the most overlooked areas in a used helicopter since there are not that many parts involved. However, the few parts that are on the tail will be the deciding factor in a stable and easy to fly...
In this video, I show you everything about tearing this helicopter down. It's pretty easy, but I promised all of the donors that I would post everything I did to it. so here it is :)
Here it is, video #2 where I show you what I have right now for the helicopter. I know I was going to upload only one video a week, but this one was a lot like the last one so I decided to go ahead and upload it.
In this video you will see the helicopter, the engine, the muffler that we are...
Here is the first video in a series of the all new Rc-Help.com Helicopter. Okay, so "all new" is not the right words lol. I can't wait to get this bird in the air.
In this series, we will be doing everything from rebuilding the head, the tail, getting the servos installed, setting up the DX8...
Hello everyone. I would like to welcome you to the next series that Rc-Help.com is putting together right now. If you have read the forum, and you should have already, you know that Marius started up a thread to accept donations to get Rc-Help.com it's very own helicopter. And with that, it all...