1. If you would like to get rid of these banners and the ads within the posts, all you have to do is sign up and they will go away!
  2. Welcome to Rc-Help, are you here looking for the PDF Plans? They are located in the store in the tab above, but you must be signed in to access that part of the site. It only takes a second to sign up!
  3. Like Us On Facebook!
    Hello Guest, it occurred to us during that last server failure that we had no way of informing the members of the site of the failure and I would like to invite you to like us on facebook so that you can get updates if the site happens to go down again. We don't post much over there unless we are updating the members so we will not flood your feed like some places do. Just click on Like and then allow notifications and that's it. See you there soon!

    Click Here To Rc-Help's Facebook page!
    Dismiss Notice
Dismiss Notice
Hey Guest, I see you are not signed up on our forum yet. Did you know Registration is FREE and is only a couple clicks away? You can even sign in from Facebook, Twitter or Google+ for your convenience! So what are you waiting for, CLICK HERE to join in on the conversation!

Replacing Xt30 Connectors With Xt60 Connectors

By Tony, Jan 10, 2018 | | |
Author Rating:
  1. Tony
    Tattu 650mah 4s Battery - TATTU 650mAh 14.8V 4S 75C Li-polymer Battery -$13.84 Online Shopping| GearBest.com
    XT60 Connectors - Special Design 10 Pairs XT60 Male + Female Bullet Connectors Plug for RC Lipo Battery -$6.57 Online Shopping| GearBest.com
    Soldering Holder Review - Qx Aluminum Alloy Multifunctional Soldering Station Xt60 Xt90 T Banana Plug

    I had the Furibee X140 sent to me, and I decided on the batteries by reading the questions at the bottom of the page. In one question, it was asked what connector it had, and an associate with Gearbest stated "XT30". So I ordered batteries that had that connector on it. Guess what, that info was wrong.

    Thankfully over the years of ordering batteries, I have a good little supply of XT60 connectors laying around from swapping over to Deans or T-Plug connectors. Now that I'm thinking about swapping over to XT60 on all of my packs, I figured I would just replace these connectors (XT30) with XT60 connectors so that when I do change over, I can use the same balance board to charge all of my batteries.

    Share This Article


To make a comment simply sign up and become a member!
  1. tntpoof
    many what i would call dangerous acts in your how to video .id say How don't ..don't use a exacto knife to remove plastic hold down straps on new batteries.. don't remove heat shrink tube with exacto knife..a butane lighter will also remove it safely.. don't expose both negative and positive terminal or wires at same time.. Use insulated clamp to pull battery lead away from other...put female end on and connector your soldering to help prevent heat distortion..
    1. Tony
      Yea, I have a lot of bad habits lmao.
  2. Admiral
    Hi Tony, I find when your soldering the wire to the plus and need to hold it, I use a piece of wet sponge, it saves the ouchies on the fingers and prevents the heat traveling up the wire to the heat shrink especially if the wires are only short.
      Tony likes this.
    1. Tony
      That is an excellent tip Keith! I have always held them and if they were really short, I would use a pair of pliers, but never thought about a wet sponge. I may have to give that one a shot!