1. If you would like to get rid of these banners and the ads within the posts, all you have to do is sign up and they will go away!
  2. Welcome to Rc-Help, are you here looking for the PDF Plans? They are located in the store in the tab above, but you must be signed in to access that part of the site. It only takes a second to sign up!
  3. Like Us On Facebook!
    Hello Guest, it occurred to us during that last server failure that we had no way of informing the members of the site of the failure and I would like to invite you to like us on facebook so that you can get updates if the site happens to go down again. We don't post much over there unless we are updating the members so we will not flood your feed like some places do. Just click on Like and then allow notifications and that's it. See you there soon!

    Click Here To Rc-Help's Facebook page!
    Dismiss Notice
Dismiss Notice
Hey Guest, I see you are not signed up on our forum yet. Did you know Registration is FREE and is only a couple clicks away? You can even sign in from Facebook, Twitter or Google+ for your convenience! So what are you waiting for, CLICK HERE to join in on the conversation!

Cars & Trucks

How To Glue Rc Car Truck Tires

Author Rating:
9116 Truggy - 9116 1/12 Scale 2WD 2.4G 4CH RC Monster Truck - RTR -$42.99 Online Shopping| GearBest.com If you guys remember when I did the review, my 3 complaints about this truck were the non oil filled shocks, which I replaced with oil filled shocks, the very tight and crunchy diff which I have since freed up and did a video on (click the "i" in the video) and the non foam filled tires. Today, we take care of the third issue! In this video, I show you how I glue up Rc car or truck...
In this video, I finally get the T-Maxx running again the way it should and we take it out for a little test drive. As always, if you have any questions, comments or suggestions, post them in the comments below!
In this video, I show you how to properly tear down and rebuild all 8 of the shocks on a Traxxas T-Maxx. Once you are done rebuilding your shocks, your truck will ride better than ever! As always, if you have any questions, comments or suggestions, post them in the comment section below.
In this video, I go through installing all of the electronics in this truck. I really should have had a servo in this thing when I built it, it would have been a LOT easier. I did end up moving the ESC to the front of the truck rather than where I Had it mounted in this video. [MEDIA=youtube]lNzmoFPB17Y[/MEDIA]
In this video, I walk you through how to completely set up the suspension on the Traxxas T-Maxx. I show you how to adjust the camber as well as how to modify an RPM Camber Gauge so you can use it on large tires. I also show you how to use an RPM Toe In Gauge to set the toe-in on the front and rear of the truck. As always, if you have any questions, comments or suggestions for future videos, post them below in the comment section.
You all have waited for this, and here it is. The Unboxing of the Team Losi 22 SCT (Short Course Truck) For a few years now, I have wanted to get back into racing. I had went to the local track (about 35 minutes from my house) a year or so ago and wanted to see about getting back into it. Well nothing panned out of that one and I never went back. But I did get some information. Seems that the SCT's were the hot ticket that everyone was running. I didn't like the SCT's, and I think that...
Here is the transmission build. Any questions just ask.
In this video, we tear into the front and rear diff's (differentials) to completely clean them, rebuild them and get them ready for some ground pounding action. As you can see in the video below, these are some of the worst gears I have ever seen. I never thought grease could get this hard! As always, if you have any questions, comments or suggestions, post them below in the comments section.
In this video, I finally got all of my parts in for the new engine including a new engine block since my last one was broke. I also show you how to get rid of light rust on the crank from sitting. Remember, the fuel these use is made up of mainly methanol, and methanol absorbs water, then the methanol evaporates leaving the water and it will rust all your steel components. I also show you how to take the rod off the piston and clean it completely where you get the max power out of that...
In this video, I show you how to completely tear down the engine out of your Traxxas T-Maxx. This is not as hard as some would like you to think. We start by pulling the engine out of the truck, followed by removing the ez start then removing the backplate, sleeve, piston & rod and crank after removing the clutch bell, clutch, and flywheel. And if you want to see a very nasty engine, this is it. This is NOT what you want your engine to look like. As always, if you have any questions,...
If you are looking to get into any hobby, most likely you are going to look for some good deals on used products. In this video, I show you what you are more than likely going to get. I purchased both of these trucks for a really good deal and I couldn't pass it up. Such a good deal as a matter of fact, that the issues I found when looking at them was not an issue. Take a look at the video to see what you could possibly get for a little amount of money on a used nitro truck. And...
It seems all we do now days is play with things that fly. Well, in this video, we get back to earth and play around with this little 1/12th scale Truggy. For a $33 vehicle, this thing is pretty sweet. Check out the product review video and let me know what you think! Once I get a track built, I will shoot some more video of it going around the track.
Here is the build of the Team Losi 22SCT. If you have any questions, all you have to do is ask. [MEDIA=youtube]id=Ufnrw_fKKs0;t=1[/MEDIA]
Building new shocks is a lot like rebuilding used shocks. Take your time, and you will get them correct every time! [MEDIA=youtube]YHG59zbcbZA[/MEDIA]
In this video, I tear into the transmission to show you what to look for when going through your truck. As always, if you have any questions, comments or suggestions, post them in the comment section below.